Page 232 - Demo
P. 232
Standard Guideline
Screw
Standard Finish Cam Lock :
Chrome Plating, Add ‘PC’ for Powder Coating
Wing Knob :
Powder Coating, Add ‘CH’ for Chrome Plating
‘L’ Handle :
Powder Coating, Add ‘CH’ for Chrome Plating
‘T’ Handle :
Powder Coating, Add ‘CH’ for Chrome Plating
Cam :
Yellow Zinc Plating, Add ‘BZ’ for Blue Zinc Plating
No. of Keys in Standard Lock Single Point Lock :
1 Key
3 Point Lock :
2 Keys
All ‘L’ Handles :
1 Key
All ‘T’ Handles :
1 Key
Combination Locks :
2 Keys
Swing Handle needs to be used for unlocking the door only. Kindly do not open the door by pulling the Swing Handle.
Operational Guidelines
All rights reserved in favour of Darshana Industries Pvt. Ltd. ©2022
Cut Out
DARSHANA
Quarter-Turn Lock
DARSHANA
Quarter-Turn Locks can be installed in the Cut Out without removing the screw. This is made possible by special internal stopper between the inner & Outer.
Assemble Quarter-Turm in standard Cut Out as Specified for each Lock
Slide nut over the cam against the outer and tighten the Nut
The Quarter-Turm Lock is completely assembled and operational
Standard Cut Out as mentioned in the Catalogue needs to be used for each Lock. We are not Responsible for Failure of Lock due to non-standard Cut Out.